PIR-5010C Illuminated Sensor
Home / Products / PIR Sensors / PIR-5010C Illuminated Sensor
Model No : PIR-5010C
Functions & Characteristics:
- Special circuit design and with auto light feed-up patented design which can resist spark, surge and noise and light will not flash because it’s near the heat source.
- Time, day & night and sensitivity can be adjusted. It can be installed on the wall and the ceiling.
- Combine with any lamp such as Incandescent lamp, Fluorescent lamp, energy saving lamp or LED lamp.
- DIY Light Sensor Application Places: Hallway, door gate, corridor, stairs, garage, balcony and basement...etc.
Specification:
| Model No. | PIR-5010C Illuminated Sensor |
|---|---|
| Power Supply | AC100V ~ 240V, 50HZ/60HZ |
| Max. Load | Incandescent lamp: 60W. Energy saving lamp: 23W |
| Power Consumption | standby: 220V-35mA/110V-17mA |
| Sensing Angle | Up&Down:<130°, R&L:<90° (at 25°C) |
| Sensing Distance | 8m (at 25°C ) |
| Off Delay time | 15~600 sec. |
| Warm-up Procedure | Install in the daytime: the lamp will flash 3 times after the charge. Install in the nighttime: the lamp will light for about 30 seconds then automatically shut off after energized. |
| Dimension | 10×10×7cm |
| Weight | 135g |
| Wiring | 2 IN or AC Plug wire |
Instructions( Three adjustable knobs provided as described below):
Adjust for day & night.
Sun: The DIY light sensor operates whenever people arrive.
Moon: It only operates at dark surroundings.
Adjust for off delay time.
0: about 15 seconds. 5: about 600 seconds.
Adjust for sensitivity.
Turn left: short sensing distance. Turn right: long sensing distance.
Sensing Range and Distance:
Wiring Diagram:
Application place:
